<p dir="ltr">There is a FTDI seríal port on minnowboard max for those cases to find a solution even without input signal on screen... </p>
<div class="gmail_quote">El 23/10/2015 14:34, "Rico Miledi" <<a href="mailto:rico.miledi@biodot.com">rico.miledi@biodot.com</a>> escribió:<br type="attribution"><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><div dir="ltr"><div>I was looking at the TinCanTools flasher, however as the board is brand new I do not see why I should need to do this.</div><div>I was looking for confirmation that the board is bad and I think I have just received it - thank you.</div><div><br></div><div>r</div><div class="gmail_extra"><br><div class="gmail_quote">On Fri, Oct 23, 2015 at 11:47 AM, Eric <span dir="ltr"><<a>ericolv@cox.net</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><div lang="EN-US" vlink="purple" link="blue"><div><p class="MsoNormal"><span style="font-size:11.0pt;font-family:"Calibri","sans-serif";color:#1f497d">Sounds like the first one I bought (still dead).   I had to send it back, they re-flashed it and sent it back.  It worked for a while then went dead again.  If you have a SPI flasher, you can try to re-flash the board (SPI Hook TinCanTools.com or DediProg SF 100, the first one is <i>much</i> cheaper).  However, this did not work for mine.    <u></u><u></u></span></p><p class="MsoNormal"><span style="font-size:11.0pt;font-family:"Calibri","sans-serif";color:#1f497d"><u></u> <u></u></span></p><p class="MsoNormal"><b><span style="font-size:10.0pt;font-family:"Tahoma","sans-serif"">From:</span></b><span style="font-size:10.0pt;font-family:"Tahoma","sans-serif""> elinux-MinnowBoard [mailto:<a>elinux-minnowboard-bounces@lists.elinux.org</a>] <b>On Behalf Of </b>Rico Miledi<br><b>Sent:</b> Thursday, October 22, 2015 5:39 PM<br><b>To:</b> MinnowBoard Development and Community Discussion<br><b>Subject:</b> Re: [MinnowBoard] MinnowBoard Max - no Input signal on screen<u></u><u></u></span></p><p class="MsoNormal"><u></u> <u></u></p><div><span><div><p class="MsoNormal">I only pressed the power switch after I tried different monitors and power supplies (I misstated the rated amperage of the power supply I am currently using - it is 3A instead of 2.5A).<u></u><u></u></p></div><div><p class="MsoNormal"><u></u> <u></u></p></div><div><p class="MsoNormal">I just turned it on - left it on for a minute then pressed the power switch - nothing appeared to happen the one LED that was on (D1 - next to the button) did not flicker - I have never seen D2 go on.<u></u><u></u></p></div><div><p class="MsoNormal"><u></u> <u></u></p></div></span><div><p class="MsoNormal">r<u></u><u></u></p></div></div><div><div><div><p class="MsoNormal"><u></u> <u></u></p><div><p class="MsoNormal">On Thu, Oct 22, 2015 at 5:11 PM, Rico Miledi <<a>rico.miledi@biodot.com</a>> wrote:<u></u><u></u></p><div><div><p class="MsoNormal">Yes - nothing seemed to change.<u></u><u></u></p></div><div><p class="MsoNormal"><span style="color:#888888"><u></u> <u></u></span></p></div><div><p class="MsoNormal"><span style="color:#888888">r<u></u><u></u></span></p></div></div><div><div><div><p class="MsoNormal"><u></u> <u></u></p><div><p class="MsoNormal">On Thu, Oct 22, 2015 at 4:12 PM, David Byte <<a>dbyte@suse.com</a>> wrote:<u></u><u></u></p><div><div><p class="MsoNormal">Did you press the power button near the blue LEDs?<br><br>Sent from my iPhone. Typos are Apple's fault. <u></u><u></u></p></div><div><div><div><p class="MsoNormal" style="margin-bottom:12.0pt"><br>On Oct 22, 2015, at 6:10 PM, Rico Miledi <<a>rico.miledi@biodot.com</a>> wrote:<u></u><u></u></p></div><blockquote style="margin-top:5.0pt;margin-bottom:5.0pt"><div><div><div><p class="MsoNormal">I have been trying to follow the setup procedures for a new MinnowBoard Max as described on:<u></u><u></u></p></div><div><p><span style="font-size:10.0pt"><a>http://wiki.minnowboard.org/MinnowBoard_MAX_HW_Setup</a><u></u><u></u></span></p><p><span style="font-size:10.0pt">I have a 2.5Amp AC to 5V DC power supply (positive on the inside of the barrel) that shows a voltage of 5.4V without a load (just using a multi-meter) and have tried several monitors but each of these reports no signal input.<u></u><u></u></span></p><p><span style="font-size:10.0pt">The board shows only has one illuminated led light when power is applied - I believe that there should be two?<u></u><u></u></span></p><p><span style="font-size:10.0pt">Is the board defective or should I be doing something else (it was purchased recently from Mouser).<u></u><u></u></span></p><p><span style="font-size:10.0pt">Thank you in advance for any help.<u></u><u></u></span></p><p><span style="font-size:10.0pt">Rico<u></u><u></u></span></p></div></div></div></blockquote></div></div><blockquote style="margin-top:5.0pt;margin-bottom:5.0pt"><div><p class="MsoNormal">_______________________________________________<br>elinux-MinnowBoard mailing list<br><a>elinux-MinnowBoard@lists.elinux.org</a><br><a>http://lists.elinux.org/mailman/listinfo/elinux-minnowboard</a><u></u><u></u></p></div></blockquote></div><p class="MsoNormal" style="margin-bottom:12.0pt"><br>_______________________________________________<br>elinux-MinnowBoard mailing list<br><a>elinux-MinnowBoard@lists.elinux.org</a><br><a>http://lists.elinux.org/mailman/listinfo/elinux-minnowboard</a><u></u><u></u></p></div><p class="MsoNormal"><u></u> <u></u></p></div></div></div></div><p class="MsoNormal"><u></u> <u></u></p></div></div></div></div></div><br>_______________________________________________<br>
elinux-MinnowBoard mailing list<br>
<a>elinux-MinnowBoard@lists.elinux.org</a><br>
<a rel="noreferrer">http://lists.elinux.org/mailman/listinfo/elinux-minnowboard</a><br>
<br></blockquote></div><br></div></div>
<br>_______________________________________________<br>
elinux-MinnowBoard mailing list<br>
<a href="mailto:elinux-MinnowBoard@lists.elinux.org">elinux-MinnowBoard@lists.elinux.org</a><br>
<a href="http://lists.elinux.org/mailman/listinfo/elinux-minnowboard">http://lists.elinux.org/mailman/listinfo/elinux-minnowboard</a><br>
<br></blockquote></div>