<div dir="ltr"><div>I have been trying to follow the setup procedures for a new MinnowBoard Max as described on:</div><div><font size="2"><p><a href="http://wiki.minnowboard.org/MinnowBoard_MAX_HW_Setup">http://wiki.minnowboard.org/MinnowBoard_MAX_HW_Setup</a></p><p>I have a 2.5Amp AC to 5V DC power supply (positive on the inside of the barrel) that shows a voltage of 5.4V without a load (just using a multi-meter) and have tried several monitors but each of these reports no signal input.</p><p>The board shows only has one illuminated led light when power is applied - I believe that there should be two?</p><p>Is the board defective or should I be doing something else (it was purchased recently from Mouser).</p><p>Thank you in advance for any help.</p><p>Rico</p></font></div></div>