<div dir="ltr">Hello,<div><br></div><div>I have a debuggable 0.80 firmware for MBMax.</div><div><span style="font-family:'Helvetica Neue',Arial,sans-serif;font-size:15px;line-height:20px"><br></span></div><div><span style="font-family:'Helvetica Neue',Arial,sans-serif;font-size:15px;line-height:20px">The efi boots but in the shell when I type '?' to list of available commands it shows a small list compared to all the commands mentioned here </span><font face="Helvetica Neue, Arial, sans-serif"><span style="font-size:15px;line-height:20px"><a href="http://wiki.minnowboard.org/Shell_Commands">http://wiki.minnowboard.org/Shell_Commands</a> Why are not all the commands available? </span></font></div><div><font face="Helvetica Neue, Arial, sans-serif"><span style="font-size:15px;line-height:20px"><br></span></font></div><div><font face="Helvetica Neue, Arial, sans-serif"><span style="font-size:15px;line-height:20px">I need a command that can show me the symbol table entries. I read somewhere that there is a 'mem' command for that. But that command is not in the list. </span></font><span style="font-size:15px;line-height:20px;font-family:'Helvetica Neue',Arial,sans-serif">Does someone know what command I can use to see the symbol table entries? </span></div><div><span style="font-size:15px;line-height:20px;font-family:'Helvetica Neue',Arial,sans-serif"><br></span></div><div><span style="font-size:15px;line-height:20px;font-family:'Helvetica Neue',Arial,sans-serif">Thanks</span></div><div><span style="font-size:15px;line-height:20px;font-family:'Helvetica Neue',Arial,sans-serif">Supriti </span></div><div><font face="Helvetica Neue, Arial, sans-serif"><span style="font-size:15px;line-height:20px"><br></span></font></div><div><br></div></div>