[MinnowBoard] Minnownoard max design with Gerber fils and install it
zahra rahimkhani
zrahimkhani2014 at gmail.com
Thu Nov 3 07:56:36 UTC 2016
-I use the Max Gerber files
-The both of Leds are on but them have not delay when they are turning on .
-It was got with BJA device.
_I used BAYTRAIL-IFH8065301567311.
-Nothing do not come on serial port
-I do not know how debug frimwear .
-I can not sure about BGA components How check them ?
On 03/11/2016 10:49 AM, "John 'Warthog9' Hawley" <warthog9 at eaglescrag.net>
wrote:
> - Did you use the MAX or the Turbot Gerber files?
> - Do either of the LEDs (D1, D2) come on when power is applied?
> - Did you get the SoC itself placed correctly?
> - Which SoC are you using?
> - Which RAM chips are you using?
> - Does anything come out on the serial port during boot?
> - Have you tried with the debug firmware?
> - Are you sure there isn't a short on the pcb itself?
>
> If you can answer that it should get us a good starting point on trying to
> help you with what you are seeing.
>
> - John 'Warthog9' Hawley
>
> On 11/3/2016 12:01 AM, zahra rahimkhani wrote:
>
>> Hello
>> I make a minnowboard max with use from GERBER files on its website .
>>
>> but it do not work . i tested all of voltages . they are correct .
>> also freamwear was programmed by a programmer on chip 1.8 v
>>
>> but it is not work . please suggest a solve?
>>
>> thank you
>>
>>
>> _______________________________________________
>> elinux-MinnowBoard mailing list
>> elinux-MinnowBoard at lists.elinux.org
>> http://lists.elinux.org/mailman/listinfo/elinux-minnowboard
>>
>> _______________________________________________
> elinux-MinnowBoard mailing list
> elinux-MinnowBoard at lists.elinux.org
> http://lists.elinux.org/mailman/listinfo/elinux-minnowboard
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.elinux.org/pipermail/elinux-minnowboard/attachments/20161103/d61b4188/attachment.html>
More information about the elinux-MinnowBoard
mailing list