[MinnowBoard] problem with nct3012 in minnowboard max

[John Hawley]

I'm going to assume that you've flash the firmware into the spi flash
part, so lets run through some debugging thoughts I can think of while
staring at the schematic:

- I'd confirm that DC-IN is getting +5V, as more or less everything is
going to depend on that
- NM670 Should be outputting +10V and +PS_3VSB
- What voltage are you seeing on the line going into PS_TN# on the NCT3012S?

Are you using the MAX or the Turbot colateral, as that would help narrow
down what I'm looking at (though I think this is pretty close between
the two), specifically what rev it claims on the schematic would be useful.

- John 'Warthog9' Hawley

On 09/24/2016 03:09 AM, zahra rahim khani wrote:
> Hello friend 
> 
> I produce a new minnowboard  max use from schematics and pcb in website.
> 
> but my cpu always is in sleep mod and output  of  pin PS_OUT_L 7 is not
> 3.3V  and my board dont work. 
> I replace chip nct with a new chip .
> 
> please suggest to a solve 
> 
> Regard 
> Zahra
> 
> 
>  
> 
> 
> _______________________________________________
> elinux-MinnowBoard mailing list
> elinux-MinnowBoard at lists.elinux.org
> http://lists.elinux.org/mailman/listinfo/elinux-minnowboard
>