[MinnowBoard] 4GB Ram need pcb rerouting?

[Berth-Olof Bergman]

Yes, you need to do changes in UEFI sources.

Best regards,

B-O

> 16 juni 2016 kl. 10:10 skrev Grigory V. Korotov <grinux at mail.ru>:
> 
> So i just need to connect A15 and solder higher dencity chips?
> 
> Should i do any changes in uefi sources?
> 
> 
> 16.06.2016 9:52, Berth-Olof Bergman пишет:
>> It would be possible if DRAM A15 is connected, which it isn't on Minnowboard Max and Turbot. It would also be possible to use 8GB DRAM if channel 2 signals is connected. Our Minnowboard Quattro (4 cores) supports 1GB, 2GB, 4GB and 8 GB configurations. We also have an integrated nanoSSD on board, ranging from 8GB to 64GB.
>> 
>> Best regards,
>> 
>> B-O Bergman
>> Winzent Technologies
>> 
>>> 16 juni 2016 kl. 08:45 skrev Grigory V. Korotov <grinux at mail.ru>:
>>> 
>>> Hi!
>>> 
>>> Is it possible to replace currently used ddr3 chips by higher dencity chips without rerouting pcb to get total 4Gb of Ram?
>>> 
>>> Thanks
>>> 
>>> Grigory.
>>> 
>>> _______________________________________________
>>> elinux-MinnowBoard mailing list
>>> elinux-MinnowBoard at lists.elinux.org
>>> http://lists.elinux.org/mailman/listinfo/elinux-minnowboard
>> _______________________________________________
>> elinux-MinnowBoard mailing list
>> elinux-MinnowBoard at lists.elinux.org
>> http://lists.elinux.org/mailman/listinfo/elinux-minnowboard
> 
> _______________________________________________
> elinux-MinnowBoard mailing list
> elinux-MinnowBoard at lists.elinux.org
> http://lists.elinux.org/mailman/listinfo/elinux-minnowboard