[MinnowBoard] Problem with boot firmware for MinnowMax version 0.90

[AntejaVM]

Hi, 

Thank you for help. I know looking where I need to do change.  I look where
I need to add W25Q64FV... but  it look that this flash is their. 

SPI_INIT_TABLE  mInitTable[] = {
  {
  SF_VENDOR_ID_WINBOND,     // VendorId
  SF_DEVICE_ID0_W25QXX,     // DeviceId 0
  SF_DEVICE_ID1_W25Q64,     // DeviceId 1
  {
    SF_INST_WREN,           // Prefix Opcode 0: Write Enable
    SF_INST_EWSR            // Prefix Opcode 1: Enable Write Status Register
  },
  {
    {EnumSpiOpcodeReadNoAddr,     SF_INST_JEDEC_READ_ID,  EnumSpiCycle50MHz,
EnumSpiOperationJedecId           },     // Opcode 0: Read ID
    {EnumSpiOpcodeRead,           SF_INST_READ,           EnumSpiCycle50MHz,
EnumSpiOperationReadData          },     // Opcode 1: Read
    {EnumSpiOpcodeReadNoAddr,     SF_INST_RDSR,           EnumSpiCycle50MHz,
EnumSpiOperationReadStatus        },     // Opcode 2: Read Status Register
    {EnumSpiOpcodeRead,           SF_INST_SFDP,           EnumSpiCycle50MHz,
EnumSpiOperationDiscoveryParameters},    // Opcode 3: Serial Flash Discovery
Parameters
    {EnumSpiOpcodeWrite,          SF_INST_SERASE,         EnumSpiCycle50MHz,
EnumSpiOperationErase_4K_Byte     },     // Opcode 4: Sector Erase (4KB)
    {EnumSpiOpcodeWrite,          SF_INST_64KB_ERASE,     EnumSpiCycle50MHz,
EnumSpiOperationErase_64K_Byte    },     // Opcode 5: Block Erase (64KB
    {EnumSpiOpcodeWrite,          SF_INST_PROG,           EnumSpiCycle50MHz,
EnumSpiOperationProgramData_1_Byte},     // Opcode 6: Byte Program
    {EnumSpiOpcodeWriteNoAddr,    SF_INST_WRSR,           EnumSpiCycle50MHz,
EnumSpiOperationWriteStatus       },     // Opcode 7: Write Status Register
  },

Or I need to do something else. Could somebody tell me where and what I need
to change? 



--
View this message in context: http://minnowboard.57273.x6.nabble.com/MinnowBoard-Problem-with-boot-firmware-for-MinnowMax-version-0-90-tp2133p2148.html
Sent from the MinnowBoard mailing list archive at Nabble.com.