[MinnowBoard] Problem with boot firmware for MinnowMax version 0.90

[John Hawley]

If your flash part doesn't work with anything after 0.81, I'm guessing
there's a change in there between what the MinnowBoard MAX and the
MinnowBoard Turbot use (as there was a part change there I believe, and
the firmware that supported the Turbot is 0.82 I think).  Is there any
particular reason to swap it out other than for testing?  I know that
Mike would know for sure what the change was and IF it's something that
can be easily adjusted.

- John

On 3/24/2016 2:43 AM, AntejaVM wrote:
> Hi, 
> 
> Yes we replaced SMD IC flash part, because we have tested if BIOS works with
> other flashes. I'm using Minnowboard Max.  
> Original flash part is Micron and the new that we have soldered is Winbond
> W25Q64FW .  
> 
> Minnowboard Max with Winbond flash don't boot firmware version 0.90, 0.84,
> 0.83, 0.82.
> Both flash ICs boot firmware version 0.81. 
> 
> Best Regards, 
> Anteja
> 
> 
> 
> --
> View this message in context: http://minnowboard.57273.x6.nabble.com/MinnowBoard-Problem-with-boot-firmware-for-MinnowMax-version-0-90-tp2133p2140.html
> Sent from the MinnowBoard mailing list archive at Nabble.com.
> _______________________________________________
> elinux-MinnowBoard mailing list
> elinux-MinnowBoard at lists.elinux.org
> http://lists.elinux.org/mailman/listinfo/elinux-minnowboard
>