[MinnowBoard] MinnowBoard Max - no Input signal on screen
Rico Miledi
rico.miledi at biodot.com
Fri Oct 23 00:11:37 UTC 2015
Yes - nothing seemed to change.
r
On Thu, Oct 22, 2015 at 4:12 PM, David Byte <dbyte at suse.com> wrote:
> Did you press the power button near the blue LEDs?
>
> Sent from my iPhone. Typos are Apple's fault.
>
> On Oct 22, 2015, at 6:10 PM, Rico Miledi <rico.miledi at biodot.com> wrote:
>
> I have been trying to follow the setup procedures for a new MinnowBoard
> Max as described on:
>
> http://wiki.minnowboard.org/MinnowBoard_MAX_HW_Setup
>
> I have a 2.5Amp AC to 5V DC power supply (positive on the inside of the
> barrel) that shows a voltage of 5.4V without a load (just using a
> multi-meter) and have tried several monitors but each of these reports no
> signal input.
>
> The board shows only has one illuminated led light when power is applied -
> I believe that there should be two?
>
> Is the board defective or should I be doing something else (it was
> purchased recently from Mouser).
>
> Thank you in advance for any help.
>
> Rico
>
> _______________________________________________
> elinux-MinnowBoard mailing list
> elinux-MinnowBoard at lists.elinux.org
> http://lists.elinux.org/mailman/listinfo/elinux-minnowboard
>
>
> _______________________________________________
> elinux-MinnowBoard mailing list
> elinux-MinnowBoard at lists.elinux.org
> http://lists.elinux.org/mailman/listinfo/elinux-minnowboard
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.elinux.org/pipermail/elinux-minnowboard/attachments/20151022/67920b17/attachment.html>
More information about the elinux-MinnowBoard
mailing list