[MinnowBoard] MinnowBoard Max - no Input signal on screen

[David Byte]

Did you press the power button near the blue LEDs?

Sent from my iPhone. Typos are Apple's fault.

On Oct 22, 2015, at 6:10 PM, Rico Miledi <rico.miledi at biodot.com<mailto:rico.miledi at biodot.com>> wrote:

I have been trying to follow the setup procedures for a new MinnowBoard Max as described on:

http://wiki.minnowboard.org/MinnowBoard_MAX_HW_Setup

I have a 2.5Amp AC to 5V DC power supply (positive on the inside of the barrel) that shows a voltage of 5.4V without a load (just using a multi-meter) and have tried several monitors but each of these reports no signal input.

The board shows only has one illuminated led light when power is applied - I believe that there should be two?

Is the board defective or should I be doing something else (it was purchased recently from Mouser).

Thank you in advance for any help.

Rico

_______________________________________________
elinux-MinnowBoard mailing list
elinux-MinnowBoard at lists.elinux.org<mailto:elinux-MinnowBoard at lists.elinux.org>
http://lists.elinux.org/mailman/listinfo/elinux-minnowboard
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.elinux.org/pipermail/elinux-minnowboard/attachments/20151022/98db845c/attachment.html>