[MinnowBoard] MinnowBoard Max - no Input signal on screen

Rico Miledi rico.miledi at biodot.com
Thu Oct 22 23:02:49 UTC 2015


I have been trying to follow the setup procedures for a new MinnowBoard Max
as described on:

http://wiki.minnowboard.org/MinnowBoard_MAX_HW_Setup

I have a 2.5Amp AC to 5V DC power supply (positive on the inside of the
barrel) that shows a voltage of 5.4V without a load (just using a
multi-meter) and have tried several monitors but each of these reports no
signal input.

The board shows only has one illuminated led light when power is applied -
I believe that there should be two?

Is the board defective or should I be doing something else (it was
purchased recently from Mouser).

Thank you in advance for any help.

Rico
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.elinux.org/pipermail/elinux-minnowboard/attachments/20151022/f0c308e7/attachment.html>


More information about the elinux-MinnowBoard mailing list