[MinnowBoard] Problem booting with activity on I2S_FRM
Lucas De Marchi
lucas.de.marchi at gmail.com
Fri Mar 27 21:24:08 UTC 2015
Hey,
I'm using the pin GPIO_I2S_FRM for gpio in my application. However
when I boot the board, if there's any activity on this pin already,
the board doens't boot. I get nothing on serial, not even the messages
from the bios. As far as I tested this is the only pin that exhibits
this behavior.
Firmware version is 0.78. Is there anything that can be done to boot
the board even with activity on this pin?
thanks
--
Lucas De Marchi
More information about the elinux-MinnowBoard
mailing list