[MinnowBoard] Programming flash

[Robert Johnston]

Hi David,

Thanks.  Also, there was a reply from Peter Ogden that I am going to look into.

Robert

-----Original Message-----
From: David Anders [mailto:danders at circuitco.com] 
Sent: Wednesday, November 05, 2014 9:49 AM
To: MinnowBoard Development and Community Discussion; robert at layer2.com; elinux-minnowboard at lists.osuosl.org
Subject: Re: [MinnowBoard] Programming flash

Robert,

i was the one that posted that information originally. i will make an attempt to get the wiring info posted on the wiki this week. 

as a side note, i will also look into creating eagle files for an adapter board to the flyswatter2 to make this easier...

if you haven't seen an update by this time next week give me another ping..

Dave


> On November 4, 2014 at 9:02 PM Robert Johnston <robert at layer2.com> wrote:
> 
> 
> Hi,
> 
>  
> 
> Documentation (such as 
> http://www.elinux.org/Minnowboard:SPI_Boot_flash)
> indicates that the Minnowboad flash can be programmed using the 
> TinCanTools Flyswatter2.  But I have been unable to find either a 
> schematic or actual cable to connect from the Flyswatter 20 pin JTAG 
> connector to the Minnowboard 8 pin SPI connector (or even determine if 
> those are the right connectors to use).  Can anyone point me in the right direction?
> 
>  
> 
> Thanks
> 
>  
> 
> Robert
> 
> _______________________________________________
> elinux-MinnowBoard mailing list
> elinux-MinnowBoard at lists.elinux.org
> http://lists.elinux.org/mailman/listinfo/elinux-minnowboard