[MinnowBoard] Defective Minnowboard?
Rangel, Steven H
shrangel at WPI.EDU
Sun Oct 26 17:02:57 UTC 2014
Both LEDs stay lit the whole time and I made sure to flash the board with the latest MBM firmware. I came to the same conclusion that there maybe something wrong with my board. I tried email rma at minnowboard.org<mailto:rma at minnowboard.org> to use the warranty but the email just bounces back. The email does not seem to exist. I'm not sure who to connect now.
Steven
On Oct 26, 2014, at 12:28 PM, Timothy Hurita <iviguy at outlook.com<mailto:iviguy at outlook.com>> wrote:
Do both LED's stay solid the whole time or does one of them start blinking? The MBM can be a bit picky about power and the LED closest to the SATA port will blink if that's the case.
Don't take this question personally but did you flash the latest Minnowboard Max firmware or the Minnowboard v1 firmware? I ask only because I've seen some folks get the two mixed up. The latest MBM firmware is v0.73.
https://uefidk.com/content/minnowboard-max
If the firmware is correct and both LED's remain solid, and your sure that the HDMI cable and monitor are good then it does sound like there might be an issue with your board based on the debug output and the way it's acting.
Tim
_______________________________________________
elinux-MinnowBoard mailing list
elinux-MinnowBoard at lists.elinux.org<mailto:elinux-MinnowBoard at lists.elinux.org>
http://lists.elinux.org/mailman/listinfo/elinux-minnowboard
More information about the elinux-MinnowBoard
mailing list