[MinnowBoard] standoffs + feet part numbers?

[Scott Guthrie]

I can't quite figure out the hole sizes in the drawings (I don't have any
of the CAD stuff available here), but looking at the mailing list archives
and whatnot, it appears that the holes are sized for #6 screws.

A quick trip to McMaster yields the following:

For the Feet:
9540K693 <http://www.mcmaster.com/#>  Round Bumper, Rubber, 1/2" Diameter,
5/16" High, with Washer, packs of 25 ($9.91 for 25, I'm sure if you dug
around, you may find a slightly different model much cheaper) You'd need
4.  I chose the ones with a washer, as you'll be tightening one of the
screws through the foot into the bottom of the leg, so there'd be less risk
of tearout, although that's probably overkill).

The Leg:
93330A420 <http://www.mcmaster.com/#> Aluminum Female Threaded Round
Standoff, 1/4" OD, 1" Length, 6-32 Screw Size  (60 cents each, need 4)

Screws
91735A144 <http://www.mcmaster.com/#> Type 316 Stainless Steel Pan Head
Phillips Machine Screw, 6-32 Thread, 1/4" Length, packs of 50 ($4.16 for
50, again you could probably get the equivalent @ lowes or someplace
cheaper, need 8!)

That should be a start...

S.

On Mon, Oct 6, 2014 at 8:49 AM, Adam Goode <adam at spicenitz.org> wrote:

> Hi,
>
> I like the setup seen here, with the standoffs and feet:
> http://www.elinux.org/File:MinnowBoard_MAX-Top-Angled.jpg
>
> Do you have a list of part numbers for this configuration? It would be
> nice to have this on the wiki.
>
>
> Thanks,
>
> Adam
>
>
> _______________________________________________
> elinux-MinnowBoard mailing list
> elinux-MinnowBoard at lists.elinux.org
> http://lists.elinux.org/mailman/listinfo/elinux-minnowboard
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.elinux.org/pipermail/elinux-minnowboard/attachments/20141006/f031e5a7/attachment.html>