[MinnowBoard] Power on, but system not running
bo.bergman at winzenttech.com
Sun Aug 2 15:59:46 UTC 2015
It looks like you are stuck in S3 suspend/resume mode. If you are, you need to remove power completely, including the RTC battery if mounted. Wait for 10 seconds or so and then apply power. If only one LED is active now, hold the power button in for 5 seconds or more. Then release and press it again and see if that solves the problem.
> 31 jul 2015 kl. 15:41 skrev T <nailsoftruth at gmail.com>:
> I started a new post, so I didn't hijack the previous poster. I started
> as a reply search for updates to his/her issue which was similar to mine
> on this post:
> Here is my issue. I have a Minnowboard Max that is no longer starts. The
> D1 power LED is illuminated; however, the D2 On/Off status indicator LED
> is not. I did notice that before it completely stopped working; the
> system would intermittently turn off as if there was some type of power
> save mode. The Power LED would always stay illuminated, but the On/Off
> status indicator LED would turn off. I would either need to push the
> reset button, or unplug and plug in the power.
> Thanks to Dave Wei for your suggestion to read out the image that I
> programmed into the flash and compare it to the original. I did this and
> the MD5 hashes match. The power LED (D1) is illuminated so power is being
> supplied to the board; however, the On/Off status indicator (D2) is not.
> It has blinked on occasion (but mostly not) when I do something to the
> system, such as: push the reset button, or unplug a USB device, but that's
> it. I flashed a Debug ROM and connected a cable to the UART 6-wire serial
> port, but there is no longer any debug output to view.
> All things functioned well before. I'm not sure what else to do other
> than RMA. Any other suggestions? Thanks.
> elinux-MinnowBoard mailing list
> elinux-MinnowBoard at lists.elinux.org
More information about the elinux-MinnowBoard