[MinnowBoard] Resurecting a non-functioning minnowboard

Wei, David david.wei at intel.com
Fri Jul 31 03:03:51 UTC 2015


Could you use DediProg SF600 to read out the BIOS image that you programmed into the flash and then compare it with the original BIOS image?  If they are the same, your issue should not be caused by BIOS. 


Thanks,
David | SSG BIOS


-----Original Message-----
From: elinux-MinnowBoard [mailto:elinux-minnowboard-bounces at lists.elinux.org] On Behalf Of T
Sent: Friday, July 31, 2015 4:06 AM
To: elinux-minnowboard at lists.elinux.org
Subject: Re: [MinnowBoard] Resurecting a non-functioning minnowboard

 <minnow at ...> writes:

> 
> My minnowboard has been functioning well for about 6 months.  The  
> other day it did not start up.   1 blue LED comes on.   The serial  
> port monitor does not show anything.   Does this mean the board should  
> go the trash heap or is there some trick that might revive it?   
> Perhaps a jumper that resets the bios?
> 
> thanks,
> matt
> 
Any updates to this?  I am experiencing the same issue.  I have flashed with a Pre-built BIOS Firmware Binary (e.g., v0.77-0.81) using DediProg SF600, but still no luck.
-T



_______________________________________________
elinux-MinnowBoard mailing list
elinux-MinnowBoard at lists.elinux.org
http://lists.elinux.org/mailman/listinfo/elinux-minnowboard


More information about the elinux-MinnowBoard mailing list